Volume adapts to the outside noise!

• Music volume will increase as much as the noise outside.
• Use it while traveling on transport or walking by a noisy street. The main thing is that the volume will always be at the correct level without you touching the volume buttons.

Office mode comes great when your attention is needed but you still wish to listen music.

Volume drops to the noise outside.

• Need to hear when your boss, mother or friend calls you? No problem.
• AutoVolume can quickly react and even hold the volume for a pre-configured number of seconds.

Music playback can be started and controlled by the native iPod app or simultaneously by the built-in player that has access to your iPod library.

The result will be the same. Just add playlists, albums to the player.

• Have a nice-looking interface

Pre-configured profiles are available for different situations. Situations like traveling on bus or sitting in office.

You can always load the correct one, save changes, or create your own profile out of preset one.

• Don't bother re-configuring AutoVolume for different noise environments

AutoVolume is a fine-tunable system for Automatic Volume Control. That means you can configure just about everything!

• Use different averaging methods (simple average or Median average).
• Change sampling speed and duration.
• Change in/out volume characteristics (Signal-to-Noise Ratio) and many more.

You can check or change different input and output level characteristics (Signal-to-Noise Ratio) on the curve chart.

To change the curve you have to touch & hold and then drag the control points displayed on the chart, one at a time.

New level can fade in and out gracefully or it can just simply jump to the new level after the calculation.

You can set the fader's speed and incrementation level for your needs.

• No more senseless volume jumping
• Have the volume adjusted gracefully and unnoticed

With MicTouch Protection there will not be any false noise samples caused by you during clicking the microphone with your fingers.

• Volume will not go crazy while you are switching songs.

If actual output level reaches the value of minimum volume limit then it will hold the output volume at that position for a pre-configured amount of seconds.

• This way you will have a period of time to listen and look what is going on around you while the volume remains low.

AV will change the output level only when the input change is bigger then the threshold.

• This way the irrelevant amount of noise change will not have any effect on your music volume.
• Can be successfully used in Office mode too (as for minimal amount of noise to become active).